Executing Commands In The Irl Desktop; Running An Irl Program - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide
Hide thumbs Also See for Janus 2010:
Table of Contents

Advertisement

JANUS 2010 Hand-Held Computer User's Manual
nugget

Executing Commands in the IRL Desktop

You can execute commands in the IRL Desktop by:
• selecting the command from the IRL Desktop main menu.
• sending the command from the host computer. You must be running a
• scanning a bar code label that contains the command. For bar code labels to

Running an IRL Program

You can start an IRL program using any of the methods described next.
Note: You cannot execute IRL programs over an Interlnk connection.
• At the DOS prompt, type this command to start the IRL Desktop and
• From the IRL Desktop, choose the Run command in the File menu. The
• When you download an IRL program from the host computer to the
• Using a communications application on the host computer, send the Run
• Scan this bar code label with the reader to run {IRL-1}.IRL, the default
The IRL Desktop checks the syntax of the program before it runs the program.
If the program contains syntax errors, the reader emits three low pitched beeps
and the desktop displays the line number(s) of the errors along with a message
describing the error(s). Correct the program and run it again. During a syntax
check, OK and Cancel buttons are displayed along with any error messages.
Choose OK to continue the syntax check. Choose Cancel to terminate it.
7-8
3 9
helconital
communications application on the host computer, and the IRL Desktop
must be open on your reader.
scan, see the IRL commands in Chapter 11, "Reader Command Reference."
immediately start running an IRL program:
irl [filename]
where filename is the name of the IRL program to run.
desktop lists the program files in the current directory. Use
select the program you want to run and press
reader, append the Run command (//) to the end of the program. The
program begins running when the download is complete.
command to the reader. The command runs {IRL-1}.IRL, the default
program.
program:
Run IRL Program
*//*
*//*
h
j
and
e
.
to

Advertisement

Table of Contents
loading

Table of Contents