JANUS 2010 Hand-Held Computer User's Manual
nugget
Multi-Drop, User-Defined
Purpose:
Multi-Drop, User-Defined is an option of User-Defined protocol. You must set
the POL and SEL characters to define a unique device address. For help, see
"POL and SEL Combinations for Multi-Drop Protocol" in Appendix C.
Note: You must select User-Defined protocol before you can enable Multi-Drop, User-
Defined protocol. For help, see the "Communications Protocol, Configure" command
earlier in this chapter. To activate Multi-Drop, User-Defined protocol, select User-
Defined in the configuration command Communications Protocol, Activate.
Default:
Disabled
Syntax:
PMdata
Acceptable values for data are:
0
1
Scan:
One of these bar codes:
Disable Multi-Drop, User-Defined
*$+PM0*
*$+PM0*
Enable Multi-Drop, User-Defined
*$+PM1*
*$+PM1*
Data Bits
Purpose:
Sets the number of data bits the reader uses when communicating with another
device (i.e., host computer).
Note: You must select the communications port and protocol before you set the
parameters to define that protocol. For help, see the "Communications Protocol,
Configure" command earlier in this chapter.
7
Default:
12-42
3 9
helconital
Disabled
Enabled