Using A Flash Pc Card; Preparing To Use I/O Cards - Intermec Janus 2010 User Manual

JANUS 2010 Hand-Held Computer User's Manual
7. Press
8. Press
9. Press
Note: If you have trouble formatting the flash card or the reader does not recognize the
card, you may need to install additional flash card drivers. For help, see "Using PC
Cards" in Chapter 10.

Using a Flash PC Card

You can use standard DOS commands to copy, delete, and move files, and to
create and remove directories on a flash card. To learn which DOS commands
are available on the reader, see the MS-DOS Programs companion disk 2.
For example, on a JANUS 2010 with a PCMCIA Back, you can copy all the files
from drive E to drive G by typing this command at the DOS prompt:
copy e:\*.* g:
To delete all the files on the flash card in drive G, type this command at the
DOS prompt:
del g:\*.*
If you need more information about DOS commands, refer to any book that
describes DOS commands.
You can also use MCFORMAT to format an exiting partition on the flash PC
card, or display information about the card's partitions. To do so, start
MCFORMAT and choose options 2 or 4, respectively.

Preparing to Use I/O Cards

You can use I/O expansion cards in the Type II PC card drive. To use an I/O
card in the Type II drive, you need to add the I/O card drivers and utilities to
AUTOEXEC.BAT and CONFIG.SYS.
Note: Before you use an I/O card in your JANUS reader, read the documentation that
comes with the PC card for any instructions on using your card. Some cards may need
to be configured before they can be used in the reader's PC card drive.
4-22
e
if you do not want to enter a label for the card, or type a label
name (up to 11 characters long) and press
current card status followed by the next prompt.
Press return for main menu.
e
to return to the MCFORMAT main menu.
d
to exit MCFORMAT. You are ready to use the flash card.
e
. The program displays the