Intermec Janus 2010 User Manual page 311

nugget
• Clean the scanning window of
• Use IC.EXE to verify that the
• Use IC.EXE to verify that the
• Verify that the command IF
• The SCANNER.INI file contains configuration information for each type of
3 9
helconital
the laser scanner with a
solution of ammonia and water.
Wipe dry. Do not allow
abrasive material to touch the
window.
reader is configured to read the
bar code symbology you are
scanning.
correct scanner type is enabled
on the reader. For help, see the
"Scanner Devices" command in
Chapter 12.
EXIST D:\RDG.BAT CALL D:\RDG.BAT is executed from the
AUTOEXEC.BAT file. If the command is not executed, the reader cannot
decode bar code labels.
scanner device. The SCANNER.INI file must remain on drive D. If
SCANNER.INI is not on drive D, you cannot configure the Scanner Devices
(SS) parameter to any value except "All compatible scanners." Any attempt
to do so will generate an error:
When You Do This
You use IC.EXE to configure the
Scanner Devices parameter.
You scan or type a configuration
command that sets the Scanner
Devices parameter to any other
value.
You load a configuration file (such
as JANUS.INI) that sets the Scanner
Devices parameter to any other
value.
Troubleshooting
20° Angle
Result
"All compatible scanners" is the only
value you can choose for the parameter.
The reader sounds an error beep.
The reader displays an error message
and none of the changes in the INI file
are implemented.
10
2010U.175
10-29