Verifying That The Reader Is Operating Correctly - Intermec Janus 2010 User Manual

Intermec janus 2010: user guide

Hide thumbs Also See for Janus 2010:

Table of Contents

JANUS 2010 Hand-Held Computer User's Manual

Verifying That the Reader Is Operating Correctly

Once you have turned on the reader and attached an input device, your JANUS

reader is ready for operation. You can enter data by typing on the keypad or by

scanning bar code labels.

For example, to view the contents of the reader's current drive, type this

command at the DOS prompt and press

Or scan this bar code:

The directory of the current drive appears on the reader display.

MCFORMAT EXE

MS-FLASH SYS

If you cannot see the cursor after you enter the DIR command, scan this bar

code to move to the cursor's position in the reader's display area:

To learn more about the reader's display and the position of the cursor, see

"How to Use the Reader's Display" in Chapter 2.