Intermec Janus 2010 User Manual page 226

JANUS 2010 Hand-Held Computer User's Manual
nugget
The way you start the FTA on the reader determines whether the reader will be
the client or server.
To make the reader the client
1. Type this command at the reader's DOS prompt to start the FTA:
2. Type this command at the FTA prompt to open a BFT session:
3. From the reader, type the commands to transfer binary files or update the
To make the reader the server
There are two ways to make the reader the server:
1. Type this command at the reader's DOS prompt to start the FTA:
2. Type this command at the FTA prompt to make the reader the server:
3. From the host computer, type the commands to transfer binary files or
Or,
1. Send the Prepare for Reboot command from the host computer to start the
2. When you receive the Ready For Reboot message from the reader, send the
3. From the host computer, type the commands to transfer binary files or
Note: Because you cannot display the server's directories from the client, you must
already know where each target file is located on the server.
6-44
3 9
helconital
fta
open
reader's drive C.
fta
server
update the reader's drive C.
FTA on the reader.
Reboot command from the host computer to the reader. This command
reboots the reader and opens the BFT session.
update the reader's drive C.