Intermec Janus 2010 User Manual page 147

The MCFORMAT main menu appears.
1
3. Press to select Option 1. This information appears:
Create and format a new partition.
Drive Beg address
G O
Which drive would you like to select?
Drive =
4. Press the letter of the PC card drive. For example, press
card in the Type II PC card drive. The program displays the next prompt:
Would you like to format entire card with FLASH(1) or FTL(2) (1/2)?
1
5. Press to format the entire card in an MS-Flash format, or press
format the entire card in an FTL flash format. The program displays the
next prompt:
Are you ready to format drive G: with FTL format (Y/N)?
Note: For most applications, Intermec recommends that you format a flash card in
FTL (file translation layer) flash format. You should use the MS-Flash format
when you are using the flash card in a JANUS reader and also in another PC card
slot that supports MS-Flash format, but not FTL flash format.
Y
6. Press to begin formatting the card. The program begins formatting the
flash card and displays the percent complete as it is working. Do not
remove the flash card while the program is formatting the card.
The next prompt is:
100% complete
Format Complete
Please input a volume label. (11 Characters, Press
enter for no label)
Label =
BC
NF
Using PC Cards in the Reader
End address Type Status
4194303 Free Unformatted 4096K
4
Size
2010U.167
G
to format a flash
2
to
4-21