Intermec Janus 2010 User Manual page 295

nugget
Operating the Reader (continued)
Problem
All the files on drive E have been
erased.
3 9
helconital
Solution
The contents of drive E, the physical RAM drive, are destroyed
when you perform these tasks:
• You cold boot the reader.
• You load the reader's flash memory.
• You put the reader in Storage mode.
• You execute CONFIG.SYS after changing the command that
creates the RAM drive.
• You turn off the reader (by pressing
battery pack) while the reader is performing a warm boot.
• You removed and replaced a discharged NiCad battery pack,
instead of inserting a fully charged battery pack.
• You run an application on the reader that masks the non-
maskable interrupt (NMI). While this is acceptable on a PC, it is
not acceptable on a reader.
You must restore or copy your files to drive E.
10
Troubleshooting
q
or removing the NiCad
10-13