Using The Interactive Configuration Application - Intermec Janus 2010 User Manual

5
3 9 3 9
nugget nugget
Configuring the Reader
helconital
Loading a Configuration File Whenever You Boot You can add a command to
AUTOEXEC.BAT that configures the reader with the configuration file you
specify when you warm or cold boot the reader. If you do not use this feature,
the reader returns to its default configuration during a boot.

Using the Interactive Configuration Application

The Interactive Configuration application (IC.EXE) is a menu-driven
application that lets you create configuration files, configure the reader, and
view system information. To start IC.EXE, type this command at the DOS
prompt and press :
ic
Or scan this bar code:
*IC*
*IC*
The main menu appears, displaying four menus:
Configuration
File Sym Com Op
2010U.043
File Select the File menu to load or save configuration files, or return to the
default configuration. You can also display software versions, equipment
information, and available memory. You quit IC.EXE by selecting Exit from
this menu.
Sym Select the Sym menu to choose the bar code symbologies that the reader
can decode. For some symbologies, you must also configure the check digit
and label length.
Com Select the Com menu to choose a communications protocol for each
COM port, define the parameters for each protocol, and activate one protocol.
Op Select the Op menu to change the operating parameters for the reader.
These parameters include automatically turning the reader on and off, display
options, beeper control, keypad options, reader commands, and scanner
operation.
l
Note: After you select a menu, you can press to display the online help screen.
5-7