Demonstrating The Reader's Audio Signals; Using A Headphone Or Earphone - Intermec Janus 2010 User Manual

Demonstrating the Reader's Audio Signals

You can use the IMBEEP.EXE program on companion disk 3 to make the
reader sound each signal listed in the table above.
1. Copy the IMBEEP.EXE file from Application companion disk 3 to a drive
on the reader. For help, see Chapter 3, "Learning About the Software."
2. Change to the drive where IMBEEP.EXE is stored.
3. Type this command and press
imbeep
Or scan this bar code:
*IMBEEP*
*IMBEEP*
4. Follow the instructions on the screen. Press a letter from
to each audio signal the reader sounds.
M
5. Press to exit the program.

Using a Headphone or Earphone

When the reader is in a noisy environment, you can use a miniature
headphone or earphone to hear the reader's audio signals.
Plug the headphone or earphone into the audio connector at the top of the
reader, next to the scanner port.
2010U.190
Note: When a headphone or earphone is plugged into the audio connector, the reader's
external beeper is silent.
Learning How to Use the Reader
e
:
2
A L
to to listen
2-33