Using The Configuration Application On The 5020 - Intermec Data Collection PC User Manual

5020 Data Collection PC User's Manual
Helveticcond blk
Use Utilities on the 5020 You can use the Intermec Configuration application or the
Windows CE Control Panel applets on the 5020 to configure all parameters. For help
with the Configuration application, see the next section. For help with the Control
Panel, see Chapter 4, "Customizing the 5020 Using the Control Panel."
Use Web Browser After the 5020 is communicating with a PC, you can use your Web
browser and the remote Unit Management application to configure all parameters and
manage your 5020. For help, see "Using a Web Browser and the Unit Management
Application" later in this chapter.
Use SNMP Commands After the 5020 is communicating in your network, you can use
an SNMP management station to send SNMP commands to the 5020. For help, see
"Configuring the 5020 by Using SNMP" later in this chapter.
Scan Bar Codes You can scan bar code labels to configure the 5020. However, you
can only configure a subset of the 5020 parameters by scanning bar code labels. For
help and a list of parameters, see "Configuring the 5020 by Scanning Bar Code Labels"
later in this chapter.

Using the Configuration Application on the 5020

The Configuration application lets you configure the 5020 and view system information.
You can access the Configuration application while running any application. You can
also extend and customize the Configuration application. For help, see Appendix D,
"Extending the Configuration Application."
To access the Configuration application
1. Press
2. Press
3. Press
3-4
39
jjj
and then press
# &
to highlight Programs and then press
9 !
key, or , on the 5020.)
and to highlight Configuration and then press

#
to open the Start menu.
or
&
. (You can press either Enter
&
.