Nortel DMS-100 Series Reference Manual page 501

Remote Switching Center Multi-access (RSC-M)
Datafilling table RCCINV
Subfield or
Field
refinement
EXTINFO see subfields
Note 1: For each RSC-M that table RCCINV defines, table RCCPSINV defines a corresponding
tube to allow PCM30 links to be entered on the RSC-M P-side. The PCM30 link numbers that
correspond to the EXT shelf can be entered if table RCCINV defines the EXT.
Note 2: Before the switch deletes a main or EXT shelf from an RSC-M in table RCCINV, the switch
must delete the P-side links from the main or EXT shelf from table RCCPSINV.
Note 3: Make changes to fields with multiple entries in the PROMPT mode.
Note 4: When you enter data in field C-side link table (CSLNKTAB), make sure message links are
not assigned to the same physical interface card. When the interface card supports two or more
links, separate the message links by the number of links on the interface cards. This applies to
interface link types; DS-1, DS30, DS30A, or PCM-30. Table control issues a warning if an attempt
to assign message links occurs on the same interface card. The assignment of message links to
the same interface card can cause an E1 outage (failure of all message links) if the card fails.
DMS-100 Family XPM International Translations Reference Manual, ISN06 (TDM)
Datafilling Remote Switching Center Multi-Access 5-41
(continued)
Entry
Y or N
—continued—
Description
Extension shelf information. The boolean field
EXTIINFO is set to default value N (no), and
indicates the occurrence of an EXT shelf.
When this boolean is set to Y (yes), extra fields
display to enable the datafill of RSC-M EXT
shelves. This field includes the shelf
parameters of the EXT that contains the
following subfields:
EXTSHELF
EXTFRTYP
EXTFRNO
EXTSHPOS
EXTFLOOR
EXTFLOOR
EXTROW
EXTFRPOS
EXTEQPEC
EXTSIDE
If the XPM is an RSC-M equipped with an EXT
shelf, enter Y (yes) and datafill the following
fields.
(continued)