Nortel DMS-100 Series Reference Manual page 314

4-64 Datafilling BAS on RSC-S UK / Europe
Basic call processing
Datafilling table RCCINV
Subfield or
Field
refinement
PROTOCOL
NT7X05AA
CMRLOAD
TONESET
PROCPEC
E2LOAD
Note: When you enter field C-side link table (CSLNKTAB), make sure message links are not
assigned to the same interface card. When the interface card supports a minimum of two links,
separate the message links by the number of links on the interface cards. This action applies to all
interface link types. The interface link types are DS-1, DS30, DS30A, or PCM-30. Table control
issues a warning when you attempt to assign message links on the same interface card. If you
assign message links to the same interface card, an E1 outage can occur if the card fails. An E1
outage is a failure of all message links.
297-8331-815 Standard 10.01 August 1999
(continued)
(continued)
Entry
HDLC or
DMSX
NT7X05AA
alphanumeric
AUS100
MX77AA
MX77AA
alphanumeric
—continued—
Explanation and action
Protocol. Defines if HDLC mode is present and
is active. If so, the remote shelf operates in
HDLC after initialization. The remote PM must
be busied before this value is changed. Entry is
mandatory if the NTMX76 card is datafilled.
If you enter NT7X05AA, the system prompts for
the slot_number. Slot numbers for the
NT7X05AA in the RCO2 are 5 and 21, or 7 and
23.
The CLASS modem resource load. Enter the
CMR loadname.
Tone set. Enter AUS100 for international
applications. For other applications, enter a
blank for DEFAULT.
Processor equipment product engineering
codes. Enter the PEC of the 6X45 type card in
units 0 and 1 of the RCO2. The PEC must
reflect the minimum firmware capabilities in the
processor complex of each unit. For the RCO2,
the entry value MX77AA has been added.
EEPROM file. Contains the name of the loadfile
that is loaded in the NTMX77AA EEPROM.