Nortel DMS-100 Series Reference Manual page 477

Remote Switching Center Multi-access (RSC-M)
Datafill tables for RSC-M interfaces
Table Purpose of table
CLLI Common language location identifier. Identifies the far end of each
announcement, tone, trunk group and test trunk. Also identifies national
milliwatt test lines, and service circuit used in the RSC-M subsystem.
SITE Site. Allows the DMS switch to recognize the remote equipment tied to the host.
PMLOADS Peripheral module loads. Stores a load map between the load names and
devices that contains the loads. This permits auto load to locate load files
without the intervention of operating company personnel.
PMNODES Peripheral module nodes. Read-only table, that the DMS switch uses to control
XMS-based peripheral module (XPM) unit node tables. The system enters data
in table PMNODES when entries are added or changed in inventory tables. An
entry is present in table PMNODES for the subtending nodes of each XPM.
LTCINV Line trunk controller inventory. Contains the inventory data, except the P-side
link assignment, for PM types. This table defines the PLGC as the datafill for
the LGCOi+ on the C-side of the RCO2.
CARRMTC Carrier maintenance control. Allows the DMS switch administration to enter
maintenance control information in peripherals, out-of-service (OOS) limits,
alarms, and system return-to-service (RTS) occurrences.
RCCINV Remote cluster controller inventory. Contains the RSC-M inventory data, except
the P-side link assignments. Table RCCINV allows a limited set of standard
plain old telephone service (POTS) line execs, and an EXT shelf definition for
RSC-Ms. Table RCCINV stores data about the RSC-M node and the C-side
connections to the C-side host node.
Note: The SERVORD tool normally adds the lines. Refer to the SERVORD section of this
document for an example.
DMS-100 Family XPM International Translations Reference Manual, ISN06 (TDM)
Datafilling Remote Switching Center Multi-Access 5-17
—continued—
(continued)