Nortel DMS-100 Series Reference Manual page 446

4-196 Datafilling Firmware downloading on RSC-S UK / Europe
Firmware downloading
Note: By using the LOADFW command with the UPGRADE option, the
firmware is upgraded to the new firmware load.
When this procedure is performed on a by-unit basis, perform a switch of
activity (SwAct) followed by the RTS command. Execute the LOADFW
command with the UPGRADE option on the now inactive unit.
Translations table flow
The following list describes firmware downloading translations tables:
297-8331-815 Standard 10.01 August 1999
(continued)
Table PMLOADS stores the device location of every peripheral module
(PM) load file to map between load names and load devices. The PM
load files must be present in table PMLOADS before the files can be
present in inventory tables. Load information is in field LOADNAME
and associated entries are in field LOAD for tables LTCINV, LCMINV,
and RMMINV.
Table LTCINV contains inventory data for PM types, except the P-side
link assignments. This table defines the PCM-30 line group controller
(PLGC) or line group controller overseas (LGCO) on the C-side of the
RCO2. Field LOAD contains load information for this table. The load
information corresponds to the LOADNAME tuple from table
PMLOADS.
Note: The RSC-S can be configured with the PLGC or the LGCO. For
both configurations, the PLGC must be the data entry.
Table RCCINV maintains a list of RCO2s entered in the DMS that
contains RCO2 inventory data, except P-side link assignments. Table
information identifies the location of the RCO2. Table information
identifies the required load and execute lineups of the RCO2, and the
network link connections of the RCO2. Table RCCINV contains the
RCO2 C-side PCM-30 assignments. Table RCCINV also contains
intraswitching data.