Nortel DMS-100 Series Reference Manual page 311

Datafilling table RCCINV
Subfield or
Field
refinement
FRTYPE
Enter the location of the RCO2 in fields FRNO, SHPOS, FLOOR, ROW, and FRPOS.
EQPEC
LOAD
EXECTAB
TRMTYPE
EXEC
Note: When you enter field C-side link table (CSLNKTAB), make sure message links are not
assigned to the same interface card. When the interface card supports a minimum of two links,
separate the message links by the number of links on the interface cards. This action applies to all
interface link types. The interface link types are DS-1, DS30, DS30A, or PCM-30. Table control
issues a warning when you attempt to assign message links on the same interface card. If you
assign message links to the same interface card, an E1 outage can occur if the card fails. An E1
outage is a failure of all message links.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
(continued)
Entry
Refer to list
MX85AA
alphanumeric
Refer to
subfields
Refer to list
Refer to list
—continued—
Datafilling BAS on RSC-S UK / Europe 4-61
Basic call processing
Explanation and action
Frame type. Enter CRSC for the RCO2 shelf.
Enter CEXT for the RCO2 extension shelf.
Equipment PEC. Enter the PEC MX85AA for
the RCO2.
Load. Enter the load for the RCO2. Make sure
that table PMLOADS contains this entry.
Exec table. Contains subfields TRMTYPE,
EXEC, and CONTMARK. Like with LTCINV,
each terminal type is associated with a
specified execs.
Note: Make changes to fields with multiple
entries in the PROMPT mode only.
Terminal type. Enter the terminal models to
use. The POTS is for normal lines. The
KEYSET for MBS/data lines. The RMM_TERM
is for remote MTC trunks. The ABTRK is for
normal trunks. The ESA is for ESA lines.
Executive programs. Enter the execs
associated with the terminal type. Examples
are POTSEX, KSETEX, DTCEX, ESAEX, and
RSMEX.
(continued)