Nortel DMS-100 Series Reference Manual page 353

Datafilling table REXSCHED
Subfield or
Field
refinement
ENABLE
PERIOD
PARALLEL
DAYSDSBL
CONTMARK
Note: This table only applies to REX test controllers for series 3 peripherals, applications and file
processors. Only available REX tests appear in this table. The REXSCHED table is empty when
REX tests are not available.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
(continued)
Entry
N or Y
1 through 7
1 through 99
character
+ or $
—end—
Datafilling BAS on RSC-S UK / Europe 4-103
Basic call processing
Explanation and action
Enable. Enter either N(o) or Y(es) to disable or
enable the REX test. The default value is
Y(es).
Period. Enter a number between 1 and 7 to
represent the minimum number of days
between two consecutive REX tests on the
same object. The system must run each test a
minimum of once a week. The range is 1
through 7. The default value is 1.
Parallel. Limits the number of REX tests that
can occur in parallel for one group. You can
limit the number of parallel REX tests in a
group. The default value is set to the maximum
number allowed by the maintenance software
for each REX tests. The resources required for
each test determine this value. The range is 1
through 99.
DAYSDSBL. List the days when the system
must not invoke the REX test. The day refers to
the start time of the REX test. An ALL entry
means that the test is disabled every day. The
range is the set of MON, TUES, WED, THU,
FRI, SAT, SUN, ALL, NONE. The default is
NONE (every day).
Continuation Mark. Enter a plus sign (+) to
indicate the line continues onto the next record.
If the line does not continue onto the next
record, enter a dollar sign ($).
(continued)