Nortel DMS-100 Series Reference Manual page 285

The following table describes the entries for Basic call processing for table
CLLI. The table describes the fields that apply directly to Basic call
processing. The following example does not apply to a Gateway Switching
Center. Refer to the data schema section of the Translations Guide for a
description of the other fields.
Datafilling table CLLI
Subfield or
Field
refinement
CLLI
PLACE
CLLI PROV
(continued)
BLDG
TRAFUNIT
SUFX
ADNUM
Note 1: The maximum number of CLLI codes is 8192.
Note 2: The SIZE field in table DATASIZE allocates memory for entry with field DATSKEY equal to
CLLI.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling BAS on RSC-S UK / Europe 4-35
Basic call processing
Entry Description
refer to Common language location identifier is a
subfields 16-character field. This field identifies the far
end of each announcement, tone, trunk group,
test trunk, national milliwatt test lines, and
service circuit. The recommended subfields are
PLACE, PROV, BLDG, TRAFUNIT and SUFX.
alphanumeric Place is a 4-character code. This code
identifies the name of the city or town at the far
end of each group.
alphanumeric Province or state is a 2-character code. This
code identifies the province or state at the far
end of the trunk group.
alphanumeric Building is a 2-character code. This code
identifies the building number at the far end of
the trunk group.
alphanumeric Traffic unit is a 3-character code. This code
identifies the destination of the traffic unit at the
far end of the trunk group.
alphanumeric Suffix is a 1-character code. This code
identifies trunk groups that terminate at the
same CLLI location.
0 to (size of Administrative trunk group number. Enter a
CLLI table number from 0 through a number 1 less than
minus 1) the size of table CLLI that appears in table
DATASIZE. The maximum size is 4095.
—continued—
(continued)