Nortel DMS-100 Series Reference Manual page 448

4-198 Datafilling Firmware downloading on RSC-S UK / Europe
Firmware downloading
Datafilling office parameters
Firmware downloading does not affect office parameters.
Datafill sequence
The following table lists tables that require data to use firmware
downloading. Enter the tables in the order that the tables appear in the list.
Datafill tables required for firmware downloading
Table Purpose of table
PMLOADS PM loads. Stores the device location of every PM load file to map between load
names and load devices. This table permits autoload to locate load files without
personnel. Table PMLOADS must contain the expanded peripheral module
(XPM) load files before the load files are entered in XPM inventory tables.
LTCINV Line trunk controller inventory. Contains the inventory data for PM types, except
the P-side link assignment. This table defines the PCM-30 line group controller
(PLGC). This table also defines the line group controller overseas (LGCO) on
the C-side of the RCO2.
RCCINV Remote cluster controller inventory. Contains inventory data for the RCO2,
except P-side link assignments. The RCO2 C-side PCM-30 assignment entries
occur in table RCCINV.
Datafilling table PMLOADS
Table PMLOADS stores the device location of every PM load file to map
between load names and load devices. The system automatically reloads
PMs that contain a load with data that may be corrupt. This reload allows
autoload to locate load files without personnel and reduces recovery time.
The PM load files data must be present in table PMLOADS before the load
files are entered in inventory tables. For both the first data entry and the
dump and restore process, the system adds tuples in PMLOADS. The
system adds tuples in PMLOADS when LTCINV and RCCINV tuples are
added.
Enter a dummy entry if the load name is not present in the table already. For
switch operation, change the dummy entry to include the storage device for
the PM load file.
297-8331-815 Standard 10.01 August 1999
(continued)