Nortel DMS-100 Series Reference Manual page 247
Extended peripheral module
Hide thumbs
Also See for DMS-100 Series:
- Replacement procedures (1100 pages) ,
- Maintenance manual (762 pages) ,
- Manual (543 pages)
Table of Contents
Advertisement
Datafilling table RCCINV
Subfield or
Field
refinement
LOAD
PROCPEC
E2LOAD
Note: When you enter field C-side link table (CSLNKTAB), make sure message links are not
assigned to the same physical interface card. When the interface card supports two or more links,
separate the message links by the number of links on the interface cards. This condition applies to
all interface link types: DS-1, DS30, DS30A, or PCM-30. Table control will issue a warning if you
make an attempt to assign message links on the same interface card. Assigning message links to
the same interface card can cause an E1 outage if the card fails. The E1 outage means a failure of
all message links.
Datafill example for table RCCINV
The following examples show RCO2 sample entries. An RCO2 provisioned
with the NTMX77AA UP appears in Table RCCINV. An RCO2
provisioned with the optional NTAX74AA CAP appears in Table RCCINV.
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling Firmware downloading on RSC-S International 3-223
Firmware downloading
Entry
Explanation and action
Load. Enter the load the RCO2 must use. The
display should show a load listed in table
PMLOADS.
MX77AA
Processor equipment product engineering
MX77AA, or
codes. One PEC is required for each PLGC or
AX74AA
LGCO unit. Enter the PEC for unit 0 first. The
AX74AA
PEC must reflect the minimum firmware
capabilities in the processor complex of each
unit. For the RCO2, entry value AX74AA has
been added.
Note: When the NT7X05 PRL is entered as an
optional card, enter MX77AA MX77AA. The
value AX74AA AX74AA is not allowed as valid
when the NT7X05 PRL is entered as an
optional card. The conditions appears because
the NTAX74 CAP does not support NT7X05
PRL functionality.
alphanumeric
EEPROM file. Contains the name of the loadfile
loaded in either the NTMX77AA EEPROM or in
the optional NTAX74AA EEPROM.
Note: When the NT7X05 PRL is entered as an
optional card, enter the loadfile name for the
NTMX77 UP. The optional NTAX74AA CAP
does not support NT7X05 PRL functionality.
(continued)
Advertisement
Table of Contents
