Nortel DMS-100 Series Reference Manual page 322

4-72 Datafilling BAS on RSC-S UK / Europe
Basic call processing
Datafilling table LCMINV
Subfield or
Field
refinement
CSPMNO
PMT
EXT_PMNO
BICTST
MEMSIZE
LCMTYPE
RNGDATA
RGEQUIP
Note 1: The LCM link information that appears starts with link 0. The C-side peripheral links are in
parentheses.
Note 2: When you enter fields link information (LNKINFO) or link map (LNKMAP), make sure the
message links are not assigned to the same interface card. When the interface card supports a
minimum of two links, separate the message links by the number of links on the interface cards.
This action applies to interface link types DS-1, DS30, DS30A, or PCM-30. Table control issues a
warning when you attempt to assign message links on the same interface card. When you assign
message links to the same interface card, an E1 outage can occur if the card fails. An E1 outage is
a failure of all message links.
297-8331-815 Standard 10.01 August 1999
(continued)
(continued)
Entry
Refer to
subfields
RCO2
0 to 199
Y or N
Refer to list
LCME
refer to
subfield
Y or N
—continued—
Explanation and action
The C-side PM. Contains subfields PMTYPE
and XPMNO.
The PM type. Enter the type of peripheral
attached to the C-side of the LCM.
The PM number. Enter the PM number
attached to the LCM C-side.
The BIC relay test. Include the LCM in the next
LCM BIC Relay Test (BRT) schedule.
Memory size. Enter the memory size of the
processor card used in the LCM. Entry values
are 256K and 64K. You must set the MEMSIZE
field to 256K if BICTST is set to yes or if XLCM
overload feature is implemented. If MEMSIZE
is set to 64K, you must set BICTST to no.
The LCM type and link information. Enter LCM
or LCME for the enhanced type of LCM.
Subfields are RNGDATA and LCDI_INFO.
Ring data. Contains of subfield RGEQUIP.
Ringing equipment. Enter Y to select ringing
type and features.