Nortel DMS-100 Series Reference Manual page 108

3-84 Datafilling BAS on RSC-S International
Basic call processing
Datafilling table TRKSGRP
Subfield or
Field
refinement
SGRPKEY
CLLI
SGRP
CARDCODE
SGRPVAR
SIGDATA
DIR
OPULSTYP
OSTARTSG
IDGTIME
NUMSTOPS
Note 1: The number of trunk subgroups by the SIZE field in table DATASIZE for the entry with field
DATSKEY equal to TRKSGRP allocates memory.
Note 2: The maximum number of trunk subgroups is equal to twice the number of trunk groups.
Note 3: The maximum number of trunk subgroups that can be assigned is 4096.
297-8331-815 Standard 10.01 August 1999
(continued)
Entry Explanation and action
see subfields Subgroup key. Subfields: CLLI and SGRP.
alphanumeric CLLI. This subfield contains the code assigned
in table CLLI to the trunk group where the
subgroup belongs.
0 or 1 Subgroup number. This subfield contains the
number assigned to the trunk subgroup. For
maintenance and test trunks, the number is 0.
refer to list Card code. Enter the PEC of the maintenance
and test trunk card. Examples of values:
2X90AB, 2X96AA, and 2X11AA.
refer to Variable subgroup data. For standard signaling,
subfields this field contains subfields SIGDATA, DIR,
OPULSTYP, OSTARTSG, IDGTIME,
NUMSTOPS, CCONT, RNGBCK, ESUPR, SAT,
REMBSY, DIALMODE, and TRKGDTIM.
Note: Changes to fields with multiple entries
must be made in the PROMPT mode only.
STD Signaling data. This subfield lists the signaling
code (STD for standard signaling).
OG Direction. For maintenance and test trunks, the
entry is OG (outgoing).
NP Outgoing type of pulsing. For maintenance and
test trunks, the entry is NP (no pulsing).
WK Outgoing start dial signal. For maintenance and
test trunks, the entry is WK (wink).
2 Interdigital timing. For maintenance and test
trunks, the value is 2.
0 Number of stop/goes. For maintenance and
test trunks, the value is 0.
—continued—