Nortel DMS-100 Series Reference Manual page 359

data are downloaded during the update each night. The following section
describes the fields for office parameter RSC_ESASDUPD_BOOL and
gives an example for each field.
Fields for RSC_ESASDUPD_BOOL
Field
Name
Type
Default
Range
RSC_ESASDUPD_HOUR
The RSC_ESASDUPD_HOUR parameter is in Office Parameters Reference
Manual. This parameter specifies the daily start time for the update each
night of static data. The following section describes the fields for office
parameter RSC_ESASDUPD_HOUR and gives an example for each field.
Fields for RSC_ESASDUPD_HOUR
Field
Name
Type
Default
Range
Note that a static data update requires between three to five minutes. Set
this parameter so that the data transfer:
occurs during a low-traffic period
does not occur while an office image is taken
does not occur while system software performs automatic routine
exercise (REX) tests
To determine when the REX occurs, view parameters
CC-REX_SCHEDULED_HR and CMC_REX_SCHEDULED_HR in table
OFCENG. The CC tests take approximately 12 min. The CC tests start
15 min after the time set in the parameter. The central message controller
DMS-100 Family XPM International Translations Reference Manual XPM12 and up
Datafilling ESA lines and trunks on RSC-S UK / Europe 4-109
ESA lines and trunks
Example
RSC_ESASDUPD_BOOL
BOOLEAN
YES
YES or NO
Example
RSC_ESASDUPD_HOUR
ESASDUPD_TYPE
1 (01:00 HR), using a 24-hour clock
0 (00:00 HR) to 23 (23:00 HR)
(continued)