Service And Repairs - Toro TIMECUTTER 74685 Service Manual

Motion Control and Seat Switch Installation (continued)
Seat Switch Testing
Neutral Lock Switch Testing
TIMECUTTER® Service Manual
3433-938 Rev A
4. Install the smart speed knob to the smart speed lever. Hand tighten with the
screw securing the smart speed knob to the smart speed lever.
g301691
5. Place the LH pod into position on the machine.
6. Move the motion control from the neutral position to the neutral lock position.
7. Install the fuel cap on the LH side pod.
8. Install the 3 screws (per pod) securing the pod to the pod support brackets.
Torque screws to 11 N • m (100 in-lb).
9. Flip the seat back into position.
1. Disconnect the wire harness from the Operator Presence Switch (seat
switch), located on the bottom of the seat assembly.
2. Using a digital multi-meter set to the OHM or Continuity setting, test the
continuity between the two switch terminals.
• When the seat is vacated, the switch should NOT have continuity (open)
• When the operator is present, the switch should have continuity (closed)
The neutral switch is a single pole plunger type switch (normally open) with
two terminals. When the plunger is depressed, the circuit closes and there is
continuity between the terminals.
•
Motion Control Levers in neutral park position (OUT), the switch should have
continuity (closed)
•
Motion Control Levers in the operating position (IN), the switch should NOT
have continuity (open)
Figure 279
Page 8–11 Electrical System: Service and Repairs