Toro TIMECUTTER 74685 Service Manual page 128

Smart Speed Assembly Removal (continued)
Smart Speed Assembly Installation
Chassis: Service and Repairs
g301788
18. Move the smart speed selector to the turtle/trim position.
19. Remove the cubbie by lifting the front of each pod to maneuver the cubbie
away from the chassis.
20. Remove the 2 (9/16 inch) bolts per motion control arm.
21. Remove the top T-30 screw and 7/16 inch nut securing the damper to the
chassis and motion control actuator.
22. Disconnect the motion control neutral connector from the steering control box
by depressing the tabs on either side of the switch. Disconnect the switch
from the connector.
23. Remove the 5/16 inch screw (1 per mount) securing the 2 speed selector
rod retaining mounts.
24. Pull back on the speed selector rod lift and remove the speed selector rod
from the machine.
1. Install the speed selector rod onto the machine.
Figure 175
Page 5–78 TIMECUTTER® Service Manual
3433-938 Rev A