Toro TIMECUTTER 74685 Service Manual page 180

42 inch Stamped and 42/50/54/60 Inch Fabricated Deck
Replacement
42 inch Stamped and 42/50/54/60 Inch Fabricated Deck Removal
42 inch Stamped and 42/50/54/60 Inch Fabricated Deck Disassembly
Mower Deck System: Service and Repairs
Note: The following procedure shows the 42 inch stamped deck.
1. Park the machine on a level surface and set the parking brake. Stop the
engine, wait for all moving parts to stop and remove the key.
2. Using a spring puller, remove the deck tension spring from the deck tension
spring anchor.
3. Remove the deck belt from the PTO clutch.
4. Remove the cotter pin and washer (1 per side) from each side of the rear
deck weldment securing the rear of deck to the deck lift hanger.
5. Remove the rear lift arms from the deck weldments.
6. Raise the deck lift handle to the transport position.
7. Remove the cotter pin and washer securing the front deck hanger to front
deck weldment. Remove the rod from the deck.
8. Remove the wood blocks from under the deck.
9. Slide the deck away from the machine.
g302087
Note: Belt covers are toolless removal on 42–54 inch fabricated decks, CE
requires tools to remove.
1. Remove the 6 (5/16 inch) screws securing the LH and RH belt covers.
Remove the LH and RH belt covers.
Figure 254
Page 7–8 TIMECUTTER® Service Manual
3433-938 Rev A