Toro TIMECUTTER 74685 Service Manual page 165

Neutral Adjustment (continued)
TIMECUTTER® Service Manual
3433-938 Rev A
g302066
10. Adjust the motion control lever to access the parking brake position. Tighten
the 7/16 inch nut securing the 2 motion control levers.
11. Repeat for opposite side.
12. Perform the Tracking Adjustment procedure after neutral adjustment has
been completed for both sides.
13. Remove the M8X1.00 nut on the neutral lock stud of the transmission.
14. Connect the seat switch.
15. Install the wheel to the machine. Install the 4 (13/16 inch) lug nuts securing
the rear wheel to the hub. Torque the lug nuts to 94.5–122 N • m (70–90 ft-lb).
g302065
Figure 234
Figure 235
Page 6–11 Hydrostatic Drive System: Service and Repairs