Toro TIMECUTTER 74685 Service Manual page 119

Motion Control Actuator Removal (continued)
TIMECUTTER® Service Manual
3433-938 Rev A
g301705
17. Remove the 2 front pod mounting screws (T-30).
18. Remove the 2 screws (T-20) securing the cubbie to the chassis.
g301788
19. Move the smart speed selector to the trim/turtle position.
20. Remove the cubbie by lifting the front of each pod to maneuver the cubbie
away from the chassis.
21. Remove the 2 (9/16 inch) bolts per motion control arm.
22. Remove the top T-30 screw and 7/16 inch nut securing the damper to the
chassis and motion control actuator.
23. Disconnect the motion control neutral switch from the steering control box
by depressing the tabs on either side of the switch. Disconnect the switch
from the connector.
24. Remove the motion control actuator from the machine.
Figure 158
Figure 159
Page 5–69 Chassis: Service and Repairs