Toro TIMECUTTER 74685 Service Manual page 198

Motion Control and Seat Switch Removal (continued)
Motion Control and Seat Switch Installation
Electrical System: Service and Repairs
g301692
9. Remove the RH pod from the machine.
10. Disconnect the motion control neutral switch from the steering control box
by depressing the tabs on either side of the switch. Disconnect the switch
from the connector.
1. Connect the switch to the connector. Connect the motion control neutral
switch to the steering control box by depressing the tabs on either side of
the switch.
2. Place the RH pod into position on the machine.
3. Install the control panel. Hand tighten with the screw securing the control
panel to the RH pod.
g301692
Figure 277
Figure 278
Page 8–10 TIMECUTTER® Service Manual
3433-938 Rev A