Brake Module Installation
PTO Switch Replacement
PTO Switch Removal
TIMECUTTER® Service Manual
3433-938 Rev A
1. Install and hand tighten the 4 Philips head screws securing the bracket to the
module. Place the brake module into position on the machine.
2. Install the 2 (3/8 inch) screws securing the brake module bracket to the
chassis. Torque screws to 9–11 N • m (80–100 in-lb).
3. Install the connector to the module.
g302093
4. Install the 2 cotter pins and flat washers securing the brake rods to the brake
module.
5. Flip the seat into operating position.
6. Connect the battery by installing the positive battery cable first, then the
negative cable to the battery.
1. Park the machine on a level surface and set the parking brake. Stop the
engine, wait for all moving parts to stop and remove the key.
2. Disconnect the battery by removing the negative battery cable first, then
the positive cable from the battery.
3. Remove the Philips head screw from the control panel.
4. Disconnect the PTO switch.
Figure 282
Page 8–13
Electrical System: Service and Repairs