Toro TIMECUTTER 74685 Service Manual page 91

MYRIDE® Seat/Platform Installation (continued)
TIMECUTTER® Service Manual
3433-938 Rev A
9. Screw on the knob until hand tight. Install the ½ inch bolt and 9/16 inch
nut securing the cam to the chassis. Torque bolt and nut to 40.5–44.5 N •
m (30–33 ft-lb).
10. Install the MYRIDE® cable to the cam assembly. Move the MYRIDE®
adjustment lever to the most forward position. Using a ½ inch wrench, install
the front nut to the MYRIDE® cable.
g301755
11. Install the MYRIDE® assist spring to the MYRIDE® cam assembly and the
frame.
Note: The long end secures towards the front of the machine.
12. Add tension to the MYRIDE® adjustment spring cable. Move the MYRIDE®
adjustment lever to most rearward position.
13. Place the RH pod into position on the machine.
14. Install the control panel. Hand tighten the screw securing the control panel to
the RH pod.
Figure 104
Page 5–41 Chassis: Service and Repairs