Toro TIMECUTTER 74685 Service Manual page 122

Motion Control Actuator Installation (continued)
Chassis: Service and Repairs
g301691
14. Reinstall the fuel cap to the LH pod to prevent fuel spill. Fully tighten.
g301703
15. Install the LH pod to the machine.
Note: The LH and RH pod install are the same except the RH pod has the
control panel and smart speed knob.
16. Move the motion control from the neutral lock to the neutral position.
17. Remove the fuel cap on the LH side pod.
18. Using a T–30 torque bit, install the 3 screws securing the pod to the pod
support brackets. Repeat for opposite side.
19. Lift and install the seat to the seat rod.
Figure 163
Figure 164
Page 5–72 TIMECUTTER® Service Manual
3433-938 Rev A