Toro TIMECUTTER 74685 Service Manual page 171

Hydro Transaxle Installation (continued)
TIMECUTTER® Service Manual
3433-938 Rev A
3. Install the drive belt to the transaxle pulley.
4. Using a spring puller, install the hydro transaxle drive belt traction spring.
g302070
5. Install the motion control linkage. Install the ½ nut and 5/8 bolt securing the
motion control linkage to the transaxle. Torque nut and bolt to 22.5–25 N
• m (200–225 in-lb).
g302069
6. Install the brake rod linkage to the brake box. Install the cotter pin and
washer securing the brake rod linkage to the brake box.
7. Install the dump valve rod linkage to the transaxle. Install the cotter pin and
washer securing the dump valve rod to the transaxle.
Figure 245
Figure 246
Page 6–17 Hydrostatic Drive System: Service and Repairs