Toro TIMECUTTER 74685 Service Manual page 206

Ignition Switch Installation (continued)
Ignition Switch Testing
Electrical System: Service and Repairs
g302112
2. Connect the ignition switch.
g302096
3. Install and hand tighten the Philips head screw to the control panel.
4. Connect the battery by installing the positive battery cable first, then the
negative cable to the battery.
The ignition switch makes the proper connections for the starter, safety
circuits, and accessories. Detents inside the switch control the three switch
positions: OFF, RUN, and START. The START position is spring loaded so that it
automatically returns to the RUN position when released.
Ignition Switch Wiring Connections
Figure 290
Figure 291
Page 8–18 TIMECUTTER® Service Manual
3433-938 Rev A