Toro TIMECUTTER 74685 Service Manual page 39

Engine Removal (continued)
Engine Installation
TIMECUTTER® Service Manual
3433-938 Rev A
g300672
19. Lower the machine to the ground. Remove the engine from the chassis.
1. Install the engine onto the chassis. Loosely install the 4 hex bolts (9/16 inch),
3 bolts have a flat washer the 4th bolt going through the clutch anchor does
not have a flat washer.
2. Using an appropriate lifting device, raise the machine. Torque hex bolts to
45–56 N • m (400–500 in-lb).
g300672
3. Install the engine pulley to the crankshaft. Slide the hydro belt onto the
engine pulley. Add tension to the engine pulley.
Figure 19
Figure 20
Page 4–13 Engine: Service and Repairs