Minolta EP3010 Manual page 278

Code Description
SCEND signal failure
C06F6 (Signal does not go LOW)
SCEND signal failure
C06F7
(Signal does not go HIGH)
ERASE OFF signal failure
C06FA (Signal does not go LOW)
ERASE OFF signal failure
C06Fb
(Signal does not go HIGH)
C09## Paper Take-Up Malfunctions
Code Description
3rd Drawer upward motion
C0900
failure
3rd Drawer Lift-Up Motor
C0904
M24's failure to turn
2nd Drawer upward motion
failure
C0910
2nd Drawer Lift-Up Motor
C0914
M14's failure to turn
1st Drawer upward motion
failure
C0920
1st Drawer Lift-Up Motor
C0924
M13's failure to turn
4th Drawer upward motion
C0950
failure
4th Drawer Paper Lift-Up
C0954
Motor M25's failure to turn
Detection Timing
The SCEND signal does not go LOW even after the
lapse of 5 seconds after the TRON signal has gone
LOW.
The SCEND signal does not go HIGH even after the
lapse of 5 seconds after it has gone LOW.
The ERASE OFF signal does not go LOW even after
the lapse of 5 seconds after the SHOME signal has
gone HIGH.
The ERASE OFF signal does not go HIGH even after
the lapse of 5 seconds after it has gone LOW.
Detection Timing
See the PF-206 Service Manual.
• 2nd Drawer Lift-Up Sensor PC66 is not blocked (L)
even after the lapse of 5 seconds after 2nd Drawer
Paper Lift-Up Motor M14 has been energized.
• PC66 is not blocked (L) even if 2nd Drawer Lift-Up
Motor Pulse Sensor PC68 detects 75 pulses after
M14 has been energized.
• PC68 detects no pulses for the period of 500 msec-
onds while M14 is being energized.
• 1st Drawer Lift-Up Sensor PC65 is not blocked (L)
even after the lapse of 5 seconds after 1st Drawer
Paper Lift-Up Motor M13 has been energized.
• PC65 is not blocked (L) even if 1st Drawer Lift-Up
Motor Pulse Sensor PC67 detects 75 pulses after
M13 has been energized.
• PC67 detects no pulses for the period of 500 msec-
onds while M13 is being energized.
See the PF-206 Service Manual.
T-41