Minolta EP3010 Manual page 139

(7) RD Mode
Touch Panel
Display
RD Mode Make the initial settings of the copier for the Data Terminal.
ID Code Entering a 7-digit ID code from the 10-Key Pad enables making the
following settings. When the ID code is entered and transmitted after
the initial settings have been made, it executes the transmission of
MAINT. START to the Center.
Maintenance Used to make the initial settings and various transmissions.
DT Setting Enter the following data.
CT-ID Enter the 4-digit ID number of the Center which has been pro-
grammed in the Center personal computer.
DT-ID Enter the 6-digit ID number of the Data Terminal.
TEL No. Enter the 19-or-less-digit phone number of the modem connected to
the Center personal computer.
NOTE
1. When the office extension and outside line use different systems,
2. The time it takes the private branch exchange (PBX) system to
Common DT Settings of the following functions.
Dial Mode Select the type of telephone line of the user.
Auto Define "Yes" or "No" for the auto reception function.
Receive
NOTE
Select "Yes" if the line is dedicated to the Date Terminal.
Result Code Set the value according to the type of modem on the copier.
NOTE
Don't use this function as long as "5" has been set for it.
Report Japan only
Format
RAM Clear Reinitializes the Data Terminal.
[Tech. Rep. Mode
Setting (The default is
enter "P" for a "pulse" telephone line or "T" for a "tone" telephone
line before the outside line number.
switch from the extension line to the outside line varies depending
on the type of PBX system used. Set this time as follows.
Fixed switching time: Enter the pause code "–" (a single "–" lasts
Varying switching time:Enter the wait code "W."
Pulse line
Pulse
YES
Maintenance
S-33
Last Trouble]
Highlighted
2 sec.).
Tone line
Tone
NO
10 BIT
NO
.)