Minolta EP3010 Manual page 222

Book Second Page
Important
• This adjustment must be made after the "Adjustment of the Leading Edge Registration in
the Reduction Mode" has been made.
1. Prepare a chart as shown on the left.
• Reference line: 20 mm (B = C)
• Specifications: 20 ± 3.0 mm
• Adjust value setting range: 30 to 70
2. On the Touch Panel, touch "Orig. > Copy". Select
"Separation", and then "Book > 1" or "R-Book > 1";
then, make a copy at full size, using A4 crosswise
paper.
1136D036AA
3. If the specifications are not met, press the User
Mode key, Meter Count key, Stop key, 10-keys "0",
10-keys "0", Stop key, 10-keys "0", and 10-keys "1",
in that order, on the control panel to set the copier
into the Tech. Rep. mode.
4. Press the Stop key and then the Start key to set
the copier into the Factory Setting mode.
1149D086CA
5. Touch "Adjust" to open the "Adjust 1/2" menu, then
touch "Next" to access the "Adjust 2/2" menu.
6. Touch " " to highlight "A6 Book B-Scan Regist."
1173D021CA
7. Using the " " or " " key, change the value so that
width A falls within the specified range.
NOTE
If width A on the copy is smaller than 17.0, touch the
" " key.
If width A on the copy is greater than 23.0, touch the
" " key.
1173D021CA
8. Press the Start key.
(Check the image again. If the image does not
meet the Specifications, readjust.)
D-60