35-4.Settings In The Tech. Rep. Mode; Settings In The Tech. Rep. Mode; Function - Minolta EP3010 Manual

35-4. Settings in the Tech. Rep. Mode

(1) Function

• This function allows the Tech. Rep. to make the various functional tests and adjustments.
<Setting Procedure>
1. Select the particular function to be run.
2. Press the Start key to start the test.
3. Press the Stop key to stop the test.
Touch Panel Display
F1 Paper Passage
F3 Exp. Lamp
F5 Optimum & AE
F7 Orig. Sensor
Developer
F8 ATDC Adjust
FF F8 + F5
[Tech. Rep. Mode
A paper passage test is carried out to check for correct sensor
operation without having to wait for the copier to complete warm-
ing up.
<Procedure>
1. Select the paper source from which to feed paper and touch
"Paper Path Sensors."
2. Press the Start key. This starts a paper take-up and feeding
sequence and the copier shows "1" or "0" depending on the
condition of each sensor.
NOTE
Pressing the Stop key causes the copier to feed the paper out of it
and stop operating; another press of the Start key will resume the
paper take-up and feeding sequence.
Checks to see if the Exposure Lamp lights up properly. (It runs for
30 sec.)
Makes the following automatic adjustments: Vg level, Manual
exposure level and AE Sensor optimum exposure level. (It runs for
30 sec.)
<Procedure>
1. Touching "F5" automatically brings you to the next screen (AE
level adjustment screen).
2. Using the or key, show the desired number (40 to 60) and
press the Start key. This starts the automatic adjustment
sequence.
3. Touch "Test Copy" to check for image.
Makes an automatic adjustment of the Original Size Detecting
Sensors.
When "Developer" is pressed, "F8" and "FF" functions are dis-
played and disappear when the corresponding operation has been
completed.
Runs the Developing Unit to agitate developer and makes an auto-
matic adjustment of the ATDC Sensor level. (It runs for 5 min.)
Runs the F8 and F5 operations.
S-19

Function]

Operation