Minolta EP3010 Manual page 207

1139D215AA
Rear
Front
1139D216AA
1139D217AA
1139D218AA
1139D219AA
12. Remove one screw and the Photoswitch Mounting
Bracket.
13. Remove two screws and the Exit Rolls Mounting
Bracket Unit.
NOTE
When reinstalling the Exit Rolls Mounting Bracket Unit,
make sure that the Reinforcement Plate Unit is in con-
tact with the Exit Rolls Mounting Bracket Unit as shown
on the left.
14. Snap off two E-rings to remove the Exit Roller.
15. Remove the harness from the clamp.
16. Remove two screws and the Reinforcement Plate
Unit.
NOTE
When reinstalling the Reinforcement Plate Unit, make
sure that the Unit is in contact with the frame at the
front and rear sides of the copier as shown on the left.
D-45