Minolta EP3010 Manual page 192

Applying Toner to Cleaning Blade
Apply toner to the entire surface of the Cleaning Blade.
(Do not forget to coat the surfaces on both ends.)
Install the PC Drum.
Apply a thin coat of toner to the PC Drum.
Turn the PC Drum 1/2 turns backward, then turn it one complete turn forward.
Cleaning of the PC Drum Paper Separator Fingers and AIDC Sensor
Cleaning of the Ds Positioning Collars
Cleaning of the Paper Dust Remover
12. Using a soft cloth dampened with alcohol, wipe
clean the Paper Separator Fingers.
13. Using a brush or a soft cloth dampened with alco-
hol, clean the AIDC Sensor.
1149D062AA
14. Using a soft cloth dampened with alcohol, wipe
clean the Ds Positioning Collars.
1139D163AA
15. Remove two screws, two compression springs and
the Synchronizing Roller Unit.
NOTE
When removing the Synchronizing Roller Unit, use
care not to lose the compression springs. At reinstalla-
tion, fit the close-coiled end of the springs to the
bosses on the Imaging Unit.
1139D155AA
D-30