Minolta EP3010 Manual page 168

No. Part Name
1 Front Door
2 Control Panel
3 Original Scales
4 Original Glass
5 Rear Upper Cover
(Small)
6 Left Hinge Cover
Rear Upper Cover Remove the Original Cover. → Remove No. 6, 8 and 9. →
7
8 Right Hinge Cover
9 Upper Right Cover
10 Right Cover
11 Middle Right Cover Remove three screws that secure No. 11.
12 Right Door
13 Counter Cover
14 1st Drawer
15 2nd Drawer
16 Lower Rear Cover Remove two screws that secure the Lower Rear Cover.
17 Rear Cover
Upper Rear Cover Swing down No. 1. → Release and swing up the Upper Half of
18
19 Original Cover
Swing down No. 1. → Remove one screw that secures the
Belt. → Remove two screws that secure the Front Door (only
on one side). → Slide the Door to the side from which the
screws have been removed.
Open 1. → Loosen two screws that secure the Control panel.
Remove two screws that secure the Scales.
Remove the Original Cover. → Release and swing up the
Upper Half of the copier. → Remove the Screw Cover and one
mounting screw of No. 5.
Remove the Original Cover. → Remove one screw that
secures the Left Hinge Cover.
Remove one screw that secures No. 7.
Remove No. 11. → Remove No. 9. → Remove two screws that
secure No. 10.
Open No. 12 and remove it by lifting it up.
Remove No. 14 by snapping if off.
Slide out the Drawer and remove one screw that secures the
Stopper at the rear left corner.
Swing down No. 1. → Release and swing up the Upper Half of
the copier. → Remove two screws that secure the Rear Cover.
the copier. → Remove three screws that secure the Upper
Rear Cover.
D-6
Removal Procedure