Adjustment Of The Pc Drum Paper Separator Fingers Position - Minolta EP3010 Manual

(3) Adjustment of the PC Drum Paper Separator Fingers Position

Requirement
• The gap between the PC Drum and the PC Drum Paper Separator Fingers should be 1.0
± 0.5 mm when the Separator Solenoid is in the deenergized position.
Important
• Cover the PC Drum with the Drum Cloth to prevent it from being scratched.
• Use care not to deform the Separator Fingers during the adjustment procedure.
• Press part A shown below up against the PC Drum Paper Separator Fingers Positioning
Jig for the adjustment (to prevent the Paper Separator Fingers from being deformed).
1. Install the Sleeve/Magnet Roller Positioning Jig, to
which the PC Drum Paper Separator Fingers Posi-
tioning Jig has been fitted, onto the Imaging Unit.
1139D058AA
2. Turn the set screw on each of the two Finger Hold-
ers as necessary for the adjustment.
1139D059AA
3. Ensure that part A contacts the PC Drum Paper
Separator Fingers Positioning Jig when the Sepa-
rator Solenoid is in the deenergized position.
1139D060AA
D-69