Adjustment Of The Image Trailing Edge Erase Width - Minolta EP3010 Manual

(10) Adjustment of the Image Trailing Edge Erase Width

Requirement
• Ready a test chart (A3 or 11"x17") as shown on the left.
• Adjust value setting range: 42 to 58
• Movement equivalent to 1 step of setting value: 1.00 mm
Important
• This adjustment must be made after the "Adjustment of the Image Leading Edge Erase
Width" has been made.
• Paint a 20mm-long rectangle in black at the center of
the test chart along its trailing edge as shown.
Adjust so that the erase width along the trailing edge
of the painted area measures 0.5 to 5.5 mm.
1074D107
1. Place the chart in alignment with the reference
mark ( ) on the Original Width Scale and lower
the Original Cover.
2. Make a copy at full size (×1.000) in a single copy
run and check the image.
1139D043AB
3. If the specifications are not met, press the User
Mode key, Meter Count key, Stop key, 10-keys "0",
10-keys "0", Stop key, 10-keys "0", and 10-keys "1",
in that order, on the control panel to set the copier
into the Tech. Rep. mode.
4. Press the Stop key and then the Start key to set
the copier into the Factory Setting mode.
1149D086CA
5. Touch "Adjust" to Open the "Adjust 1/2" menu, then
touch "Next" to access the "Adjust 2/2" menu.
6. Touch " " to highlight "A13 Trailing Edge Erase
Adjust."
1173D024CA
D-64