Minolta EP3010 Manual page 142

Touch Panel
Display
Doc. Stop Posi- Adjusts the document stop position in different operating modes of the
tion Set ADF.
NOTE
A greater setting value (+ direction) moves away from the Original
Width Scale. (In "2in1 Space in between origs.," it is for greater dis-
tances between the documents.)
<Procedure>
1. Select the operating mode to be checked and load the required
2. Press the Start key. When the original is taken up and then
Sorter Check Enables the following operation checks to be performed for the Sorter.
Transport Motor The press of the Start key energizes the Transport Motor to turn the
various Transport Rollers.
NOTE
The 10-Bin Sorter is not operated.
Bin Movement The press of the Start key energizes the Bin Moving Motor to move
the bins up and down.
Stapling The press of the Start key runs a stapling sequence if paper is loaded
in the 1st Bin; if no paper is loaded, only a paper clamp motion
occurs.
Paper Aligning The press of the Start key causes a paper aligning motion to occur for
the width of the paper currently selected for use.
When "Next" is touched after any of the Sorter Check functions has
been selected, the "Input Check" screen appears. When that particu-
lar check operation is then run with this screen on the Touch Panel,
either 1 or 0 is shown after each sensor according to its state.
[Tech. Rep. Mode
1-Sided 2in1 Space in between origs.
2-Sided Auto Feeder
2 in 1 Regist Loop
Setting
43 ...................................
Stop
−7 mm ..........................0 mm ......................... +8 mm
Position
number of originals into the Document Feed Tray.
stopped, raise the ADF and adjust the position using the
key; then, feed the original once again for a recheck.
Paper Aligning Bar Home
Bin Empty
Paper Clamp Position
Paper Clamp Home
S-36
Accessory Test]
Setting
.................................. 58
50
Staple Paper Detect
Stapler Home
Bin Home Position
or