Sequential Explanation - Minolta EP3010 Manual

1173SBM0400A
4

SEQUENTIAL EXPLANATION

Numbers given in rectangles
A The power cord is plugged into the outlet.
Power cord is plugged in.
ON
DC24V for Drum heating (Power Supply Unit)
ON
Drum Dehumidifying
Heater
ON
Paper Dehumidifying
Heater
B Power Switch is turned ON.
Power Switch ON
ON
DC5V (Power Supply Unit)
ON
DC24V (Power Supply Unit)
ON
Control panel
ON
The Cooling Fan turns at full speed.
Approx. 2~12
Approx. 0.5
ON
Scanner Reference Position Sensor
If the Scanner is not at the home position, Scanner Motor is
energized to move the Scanner to the home position.
ON
Lens Reference Position Sensor
If the Lens is not at the home position, Lens Motor is
energized to move the Lens to the home position.
ON
Mirror Reference Position Sensor
If the 4th Mirror is not at the home position, Mirror Motor is
energized to move the Mirror to the home position.
C The Fusing Unit temperature reaches 210°C.
Fusing Thermistor 1 detects 210°C.
ON/OFF
Fusing Heater Lamp
The Fusing Unit temperature control is started.
in the following flowchart are timer values in seconds.
Only when Dehumidifying
Switch is ON
ON
The Cooling Fan turns at half speed.
ON
Fusing Heater Lamp
M-5