Adjustment Of The 1St/2Nd Drawer Reference Position - Minolta EP3010 Manual

(6) Adjustment of the 1st/2nd Drawer Reference Position

Requirement
Important
• If the Paper Tray of the Drawer needs to be moved for adjustment, make sure that it is
moved straight, not slantwise (as skewed feeding of paper could result).
• Ready a test chart (A3 or 11" × 17") as shown on the
left. Draw a line on the chart at a point 20 mm from
the right edge as shown.
• Dimension A on the copy should measure 20 ± 2.0
mm.
1074D089
1. Place the test chart face down on the Original
Glass and align its rear left corner with the
marker on the Original Width Scale on the left side
of the platen.
Then, lower the Original Cover.
2. Using the 1st Drawer, make two full size copies.
(Use A3 or 11" × 17" paper.)
3. Using the second copy, compare the position of the
1139D027AB
reference line on the copy with that on the test
chart.
4. If the line does not meet the requirement, slide out
the 1st Drawer, loosen the three screws shown on
the left, and move the Paper Tray as necessary to
the front or rear.
5. Using the same steps (1 through 4), adjust the ref-
erence position of the 2nd Drawer.
NOTE
If dimension A on the copy is smaller than 18 mm,
1149D019AA
move the Paper Tray to the rear. If it is more than 22
mm, move the Paper Tray to the front.
D-54