Winding Of The Scanner Drive Cable - Minolta EP3010 Manual

(4) Winding of the Scanner Drive Cable

Remark
Whenever the Scanner Drive Cable has been rewound, be sure to make the "Adjustment
of the Scanner/Mirrors Carriage Position."
Pulley C
Scanner Drive Gear
1. (With reference to the center of the entire length of
the cable) Wind one length of the cable 5 times
counterclockwise around the Pulley, starting with
the end of the D-cut on the pulley shank and work-
ing from the front to the back side. Then, secure
the cable with tape.
1149D038AB
2. Mount the Cable Drive Pulley on the Pulley Shaft
and fit the Support Plate.
1174D007AA
3. Fit the belt in position. Then secure Scanner Motor
and Spring (three screws).
NOTE
First, loosely secure the Scanner Motor and hook the
Spring in position.
Then fix the Scanner Motor to the position where it is
shifted by the Spring tension.
1149D040AA
D-24
Pulley B
Pulley A
1149D047AB