Adjust - Minolta EP3010 Manual

(2) Adjust

• This function is used to adjust the optical system before shipment from the factory and
must not be run except when the RAM Board has been replaced with a new one or mem-
ory cleared. Further, when the RAM Board has been changed or memory cleared, enter
the factory settings indicated on the Adjust Mode label affixed to the inside of the Front
Door.
Touch Panel Display
A0 Lens Focus
A1 Lens Full Size
Position
A2 Mirror Full
Size Position
A3 Feed Direction
Mag. Ratio
A4 Scan Resist
Full Size
[Factory setting
Corrects the focal length of the Lens. (Match the grouping of the
Lens being used.)
Setting
Short focal
Description length
adjustment
Adjusts the zoom ratio in the crosswise direction by varying the
Lens full size position.
Setting
42.............................
Reduction
Description
direction
Corrects the optical path length of the Mirror with respect to the
Lens focal length.
Setting
42 ............................
Reduction
Description
direction
Adjusts the zoom ratio in the feeding direction by varying the scan
speed.
Setting
42.............................
–3.2% ....................... 0%.................... +3.2%
Description
(Reduction direction)
Corrects the amount of offset along the leading edge in the full size
mode by varying the Synchronizing Roller start timing.
Setting 30...........................
–5.6m .........................±0 ....................... +5.6mm
Description
(Smaller)
S-46
Adjust]
Operation
49
50
Standard
............................ 57
50
.........................57
50
......................... 58
50
(Enlargement direction)
............................ 70
50
51
Long focal
length
adjustment
Enlargement
direction
Enlargement
direction
(Greater)