System Shutdown - Avaya IP Office Basic Edition Manual

17.9 System Shutdown

Before maintenance on the phone system it should be shutdown using one of the processes below. Just simply switching
off power to the phone system may cause data to be lost.
·
A shutdown must always be used to switch off the system. Simply removing the power cord or switching off the
power input may cause errors.
·
This is not a polite shutdown, any users calls and services in operation will be stopped. Once shutdown, the system
cannot be used to make or receive any calls until restarted.
·
The shutdown process takes up to a minute to complete. When shutdown, the CPU LED and the IP500 base card
LEDs 1 and 9 (if trunk daughter card fitted) will flash red rapidly. The memory card LEDs are extinguished. Do not
remove power from the system or remove any of the memory cards until the system is in this state.
·
To restart a system when shutdown, switch power to the system off and on again.
!
·
WARNING
This process will restart the phone system and disconnect all currently connected calls.
·
This procedure is not listed when using the Next Procedure or Previous Procedure buttons to select a
procedure.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
·
To do the above during a call, you may need to press the
option. If you access phone administration during a call, only the
buttons still affect the connected call.
2. Use the up or down
Select.
3. Dial #729.
4. At the Shutdown - Save All: prompt press Proceed.
5. When the system has completely shutdown, the phone display will be blank. The LED 1s on the front of the phone
system will fast flash red.
6. Power to the system can now be switched off.
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press
·
If the system has a
2. The phone displays System Admin.
3. Dial #729.
4. At the Shutdown - Save prompt press Enter.
5. When the system has completely shutdown, the phone display will be blank. The LED 1s on the front of the phone
system will fast flash red.
6. Power to the system can now be switched off.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #729.
4. At the Shutdown - Save All: prompt press
5. When the system has completely shutdown, the phone display will be blank. The LED 1s on the front of the phone
system will fast flash red.
6. Power to the system can now be switched off.
Phone Based Administration
IP Office Basic Edition
arrow buttons to scroll the display to System Administration. When highlighted, press
system password set, it is requested. Enter the password.
114
Enter
Comments on this document? infodev@avaya.com
PHONE button to display the Admin soft key
SPEAKER,
Feature **config (ie. Feature **266344).
22 .
- Issue 6a (Thursday, February 22, 2018)
System Maintenance: System Reset
MUTE and HEADSET
Page 309